OrderedBytes
OrderedBytes User Forum
FAQ FAQ     Search Search     Memberlist Memberlist     Usergroups Usergroups     Register Register
Profile Profile     Log in to check your private messages Log in to check your private messages     Log in Log in
Midi Controller building block
Display posts from previous:         View previous topic :: View next topic
Post new topic Reply to topic Subscribe to this topic    The OrderedBytes Forum -> MIDI
Midi Controller building block Tue Jan 24, 2017 12:36 pm  •   #10977
jrchappell



Joined: 09 May 2014
Posts: 7

I am trying to setup my Midi Plus Pad to work as a controller for plugins in Protools. I have everything working correctly except that the midi controller building block default to 0 of the 0-127 range. When I go to adjust the plugin I can only turn up not down. I have to continue to turn up until I have gone far enough to go back down. The knob is a continuous pot however the controller block is not it stops at 0 or 127 at each end. Is there a way to have it reset to 63? I prefer the block to always be in the middle if possible.

Thanks
View user's profile Send private message Reply with quote
Page 1 of 1 All times are GMT - 6 Hours
Post new topic Reply to topic Subscribe to this topic    The OrderedBytes Forum -> MIDI
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

Copyright © 2005 — 2012 OrderedBytes
All rights reserved.